![]() If the problem persists there is likely a mechanical issue, please contact our technical support through Live Chat or Ask a Question at the top of the page. Test sew on a piece of material to verify that the bobbin has been correctly installed in the bobbin case. Hold down the bobbin with your right hand, and then pull the end of the thread around the tab with your left hand.ĥ. While holding the bobbin in place with your finger, pass the thread through the slit in the needle plate. Then, with your right hand place the bobbin in the bobbin case.Ĥ. Hold the bobbin with your right hand with the thread unwinding to the left, and hold the end of the thread with your left hand. Place the bobbin in the bobbin case so that the thread unwinds in the correct direction. Remove the bobbin from the bobbin case.ģ. To resolve this issue correctly install the lower thread by following the steps below.Ģ. Instead of the appropriate tension being applied to the lower thread, it is pulled through the fabric when the upper thread is pulled up. If the upper thread appears as a single line, the lower thread is incorrectly threaded.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |